|
|
|
|
|
|
| |
|
|
|
SAE End Suction Pumps are suitable for any application requiring the convenience of an internal combustion engine as a power source. End Suction pumps must be flooded prior to operation. |
|
|
|
SAE Self-Prime Pumps are suitable for any application requiring the convenience of an internal combustion engine as a power source. |
|
|
|
The B11/2XQBS is available in 11 HP, 18 HP & 26 HP models, taylor made for applications requiring portability and high pressure on demand. Flow to 120 GPM , Heads to 320 feet. |
|
|
|
Type B End Suction Engine Drive pumps are ideal for emergency pumping requirements. Flow to 600 GPM. Heads to 320 feet. |
|
|
|
Type B Self Prime pumps are ideal for large emergency pumping requirements. Flow to 800 GPM. Heads to 225 feet. |
|
|
|
Lightweight, corrosion resistant, engineered composite pump construction make this engine-driven pump extremely versatile for applications where electrical power is not available. |
|
|
|
ClearJet models provide excellent performance with good pressure for wells to 25' deep. Self-priming after the priming chamber has been filled with water. |
|
|
|
6" Hitachi submersible motors are fully featured for many years of dependable operation. |
|
|
|
These engine-driven centrifugal pumps can be used where electrical power is not available. |
|
|
|
The ECC5 Series self-priming centrifugal pump is a rugged cast iron pump capable of priming up to 20' vertically and will handle solids up to 0.225" diameter. |
|
|
|
Full range of 1/3 - 15 HP single-phase protectors were a 4" submersible, 2- and 3-wire motor is used and for aboveground pressure-boost applications. |
|
|
|
Robust, versatile and designed for portability, typically where electrical power is not readily available. |
